Cleaning - FLUX F 550 S TR Serie Notice D'instructions Originale

6.

Cleaning

The intensity and the time intervals of the cleaning depend on the requirements on the
medium to be pumped. For intensive cleaning the motor has to be dismantled and the
pump has to be disassembled.
Attention!

Attention!






Attention!

Attention!

Attention!

> Do not immerse flange resp. drive into the cleaning agent.
> When using flammable cleaning agents, comply with safety instructions as to
explosion-proof equipment.
> When conveying food, disassemble the pump into its individual components and
clean them with appropriate cleaning agents and tools (brush). Thoroughly rinse
each component after cleaning and sterilize them, if necessary.
> After each operation with sticky or self-hardening products, the pump should be flushed
with a suitable cleaning agent. The pump should then be dismantled and the mechani-
cal seal carefully cleaned.
> On models F 550... with elastomer stators (NBR, FKM) a few drops of lubricant (oil,
glycerine, etc.) should be put on the stator and on the eccentric worm after cleaning.
Afterwards run the motor briefly.
> On models F 560... with elastomer stators (NBR) a few drops of lubricant (food-grade
oil) should be put on the stator and on the eccentric worm after cleaning.
Afterwards run the motor briefly.
> After cleaning check O-rings for damage and replace if necessary.
> Do visually check especially internal threads. In case of any sediment or dirt, clean
again by an appropriate tool (brush) and check for cleanness.
> Observe internal instructions.
38/80 Original operating instructions Eccentric worm drive pump F 550 S ... TR and Sanitary pump F 560 S ... TR
Only clean pump, motor and mains connection outside the
hazardous area.
Do not remove the motor in case of counterpressure.
First empty the fittings.
Do not use flammable liquids.
Rinse the pump by flushing an appropriate cleaning agent.
Pump, hose and fittings must be compatible with the cleaning agent.
The pump should only be immersed into the detergent up to the out-
let connection.
First pump the cleaning agent in a circuit, then rinse with clean
cleaning agent.
Provide the power supply with fault current breakers.
Clean pumps and accessories for conveying food at least once a
day carefully with an appropriate cleaning agent. To do so, dis-
assemble pump and accessory (see chapter "Dismantling /
Re-assembly).
Never store the motor in areas in which corrosive vapours exist.