Cleaning - FLUX F 550 Notice D'instructions Originale

Centering at the
bearing flange
> Insert the plug or connect the compressed air hose.
> Switch on the motor.
4

Cleaning

The pump must be cleaned after each operation. The pump, hose and filling fitting must be
resistant to the cleaning agent.
> Pull the mains plug and shut off the compressed air, respectively, and disconnect the
supply.
> Loosen the union nut (connection between motor and pump).
> Take the motor off the pump.
Attention!
•
> Clean the pump by flushing an appropriate cleaning agent.
> Pump and flexible hose must be compatible with the cleaning agent.
> The pump should not be immersed deeper into the liquid than the outlet connection.
> When using flammable cleaning agents, comply with safety instructions as to explo-
sion-proof equipment.
> After each operation with sticky or self-hardening products, the pump should be flus-
hed with a suitable cleaning agent. The pump should then be dismantled and the
mechanical seal carefully cleaned.
> On models F 550... with elastomer stators (NBR, CSM, FKM) a few drops of lubricant
(oil, glycerine, etc.) should be put on the stator and on the eccentric worm after clea-
ning. Afterwards run the motor briefly.
> After cleaning check o-rings for damage and replace if necessary.
> Do visually check internal thread. In case of any sediment or dirt, clean by an appro-
piate tool and check again for cleanness.
32 / 84
Never store the motor in areas in which corrosive vapours exist.
Original Manual High Viscosity Liquid Pumps Type F 550
and Sanitary Pumps Type F 560
Motor
Direction of
rotation arrow
Bearing flange
4 Screws with hexagonal
recessed hole