Skandika ERGOMETER WIRY Instructions De Montage page 39

Hints:
• The calorie consumption values registered and displayed with this computer merely serve as indica-
tive values for a person of medium stature with medium resistance setting, and can deviate conside-
rably from the actual medically precise calorie consumption.
• The pulse values registered and displayed with this computer are merely indicative in nature and can
deviate considerably from the actual pulse.
Error messages
ERROR 1 (E1):
Connection to gear motor (motor signal) is lost for more than 4 seconds. During power-on, the gear
motor will return to initial position automatically. Contact the customer service.
ERROR 2 (E2):
Memory error. Disconnect from mains source and retry after 1 minute. If problem still exists, contact the
customer service.
ERROR 3 (E3):
Motor cannot leave zero position. Contact the customer service.
The buttons on the handlebars:
1. RECOVERY: Press this button to start the heart recovery measurement.
2. ENTER: During setting mode, press the button to confirm any input. In stop mode, press and hold
button for min. 2 seconds to reset all data. During clock setting mode, press the button to confirm hour
/ minute.
3. UP („+"):
a. Press this button to increase the resistance during exercise.
b. During setting mode, press the button to adjust the values of time, distance, calories, age, gender
and program.
4. DOWN („-"):
a. Press this button to decrease the resistance during exercise.
b. During setting mode, press the button to adjust the values of time, distance, calories, age, gender
and program.
39