Troubleshooting - Cleanmaxx SG 5008S-5 Mode D'emploi

• Store the device in a dry, clean, frost-free location which is out of the reach of children
and animals. When you do this, place the device upright on its base on a fl at, stable
surface.

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct
the problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work. The operating
lamp does not light
up / fl ash.
No steam is
produced.
Water emerges from
the bottom of the
iron.
Smoke is emitted
from the device.
The device makes
loud pumping
noises.
25
Possible Cause / Solution
• Is the mains plug correctly inserted into the socket?
• Is the plug socket defective? Try a different socket and
check the fuse of your mains connection.
• Is the water reservoir empty? Refi ll it (see the "Use"
chapter, "Filling the Water Reservoir" section).
• The device has not yet reached operating temperature.
Wait until the temperature control lamp lights up
constantly.
• Is the temperature control on a low temperature setting?
Select a higher temperature setting.
• Is the device upright? Press the
check whether any steam emerges.
• If you have set a high temperature, the steam which is
generated is dry and almost invisible. This is exacerbated
by a high ambient temperature. Switch the temperature
control to a lower temperature to check whether the device
is producing steam.
• Have you not moved the device for some time? The
automatic safety switch-off function was activated. Take
hold of the handle so that the device switches back on and
heats up again.
• Is the water reservoir overfi lled? Pour away some water
(see the "Use" chapter, "After Use" section).
• Is the temperature control on a low temperature setting?
Select a higher temperature setting so that steam can be
generated.
• You might notice a small amount of smoke the fi rst time
you use the device. However, this is harmless and will
cease as you use the device.
• Is the water reservoir empty? Refi ll it (see the "Use" chap-
ter, "Filling the Water Reservoir" section).
steam burst button to
EN