Troubleshooting - Cleanmaxx SG-5510-6 Mode D'emploi

9. If you need to, operate the device again for a short time in order to allow any remain-
ing amounts of water to evaporate.

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct
the problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work. The tempera-
ture control lamp
does not light up.
No steam is pro-
duced.
Water emerges from
the bottom of the
iron.
Odour produced
27
Possible cause / solution
• Is the device connected to the adapter correctly and is the
mains plug pushed all the way into the plug socket?
• Is the plug socket defective? Try a different socket and
check the fuse of your mains connection.
• Is the water reservoir empty? Refi ll it.
• The device has not yet reached the operating tempera-
ture. Wait until the temperature control lamp goes out.
• Is the temperature control on a low temperature setting?
Select a higher temperature setting.
• Is the steam quantity control in position 0? Activate the
steam production.
• Press the steam burst button 2 to 3 times to start the
production of steam.
• If you have set a high temperature, the steam which is
generated is dry and almost invisible. This is exacerbated
by a high ambient temperature. Switch the temperature
control to a lower temperature to check whether the device
is producing steam.
• Is the water reservoir overfi lled? Pour away some water
(see the "After Use" section).
• Is the temperature control on a low temperature setting?
Select a higher temperature setting so that steam can be
generated.
• You might notice a slight odour caused by production re-
sidues the fi rst time you use the device. However, this is
harmless and will cease as you use the device.
EN