Troubleshooting - Cleanmaxx HN-6156-2200 Mode D'emploi

GB

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct the
problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does
not work. The
temperature control
lamp does not light
up.
No steam is
produced.
Water emerges from
the bottom of the
iron.
Odour produced
02190_de-gb-fr-nl_V0.indb 30 02190_de-gb-fr-nl_V0.indb 30
30
Possible cause/solution
• Is the device connected to the adapter correctly and is the
mains plug pushed all the way into the plug socket?
• Is the plug socket defective? Try a different socket and
check the fuse of your mains connection.
• Is the water reservoir empty? Refi ll it.
• The device has not yet reached the operating temperature.
Wait until the temperature control lamp goes out.
• Is the temperature control on a low temperature setting?
Select a higher temperature setting.
• Is the steam quantity control in position
steam production.
• Press the steam blast button 2 to 3 times to start the
production of steam.
• If you have set a high temperature, the steam which is gen-
erated is dry and almost invisible. This is exacerbated by a
high ambient temperature. Switch the temperature control
to a lower temperature to check whether the device is pro-
ducing steam.
• Is the water reservoir overfi lled? Pour away some water
(see the "After Use" section).
• Is the temperature control on a low temperature setting?
Select a higher temperature setting so that steam can be
generated.
You might notice a slight odour caused by production residues
the fi rst time you use the device. However, this is harmless and
will cease as you use the device.
? Activate the
03.03.2015 09:04:34 03.03.2015 09:04:34