Operation And Usage - Klarstein STEAKREAKTOR 2.0 Mode D'emploi

EN
30
Insert grill box and the grease drip tray
For a simplified cleaning of the device, the grill attachment may be removed. Insert
the attachment into the grill compartment. To prevent damage, make sure that the
attachment does not come into contact with the heating element. The attachment is
properly inserted when the latching hooks located on the top of the grill attachment
engage the matching bolt in the grill compartment. The grill attachment is necessary
for the safe operation of the device and must remain in the device during operation.
Removal may only take place in a fully cooled state
To remove the attachment, slightly raise until the latching hooks located at the top of the
grill attachment are released. Pull the grill insert carefully out of the front. Contact with
the heating element must be avoided to prevent damage. During the grilling of meat
products, liquid is normally released from the food. This must not enter into the interior of
the housing. Operate therefore only with the grease drip tray inserted.

OPERATION AND USAGE

Important note about the ceramic heating element:
During operation, the ceramic heating element shows a dark spot in the middle. No
heating wires can be installed at this point. However, this has no effect on the grilling
result, since the radiating behavior of the heating is diffuse and the grill surface is
evenly irradiated in the middle.