Drive Chain - Yamaha FX Nytro 2008 Manuel D'atelier

1
1
2
2-37

DRIVE CHAIN

Oil replacement
Oil replacement steps:
• Remove the right lower cover.
Refer to "COVERS" in CHAPTER 3.
• Place the drive chain cover under the drain
hole.
• Remove the oil drain bolt (along with the gas-
ket) 1 and drain the oil.
CAUTION:
Be sure to remove any oil from the heat protec-
tor.
• Install the new gasket and oil drain bolt 1.
Oil drain bolt:
16 Nm (1.6 m · kg, 11 ft · lb)
Recommended oil:
Gear oil "GL-3" 75W or 80W
Oil capacity:
0.20 L (0.18 Imp qt, 0.21 US qt)
Chain slack adjustment
1. Adjust:
• Drive chain slack
Adjustment steps:
• Loosen the locknut 1.
• Turn the adjusting bolt 2 clockwise until it is fin-
ger tight, and then loosen it 1/4 turn.
• Hold the adjusting bolt 2 in place while tighten-
ing the chain adjusting locknut 1.
Drive chain adjusting locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
INSP
ADJ