Yamaha FX Nytro 2008 Manuel D'atelier page 216

STEERING
REMOVAL
1. Straighten the lock washer tabs.
INSPECTION
1. Inspect:
• Handlebar
• Steering column
Bends/cracks/damage → Replace.
WARNING
Do not attempt to straighten a bent column.
This may dangerously weaken the column.
2. Inspect:
• Bearings (steering column)
• Collars
• Bearings (pivot arm)
Wear/damage → Replace.
• Steering column
(bearing contact surfaces)
Scratches/wear/damage → Replace.
3. Inspect:
• Tie rods
• Steering shaft
Bends/cracks/damage → Replace.
WARNING
Do not attempt to straighten bent rods. This
may dangerously weaken the rods.
4. Check:
• Rod end movement
Rod end free play exists → Replace the rod
end.
Rod end turns roughly → Replace the rod
end.
3-11
CHAS