Table des Matières
Publicité
AIR BLEEDING (HYDRAULIC BRAKE SYSTEM)/
DRIVE CHAIN
i. Repeat steps (e) to (h) until all of the air bubbles
have disappeared from the fluid.
j. Tighten the bleed screws.
Bleed screw:
6 Nm (0.6 m · kg, 4.3 ft · lb)
NOTE:
If bleeding is difficult, it may be necessary to let the
brake fluid settle for a few hours.
Repeat the bleeding procedure when the tiny bub-
bles in the system have disappeared.
k. Add brake fluid to the proper level.
WARNING
After bleeding the brake system, check the
brake operation.
DRIVE CHAIN
Oil level inspection
WARNING
The engine and muffler will be very hot after the
engine has run. Avoid touching a hot engine
and muffler while they are still hot with any part
of your body or clothing during inspection or
repair.
1. Place the machine on a level surface.
2. Check:
• Oil level
7
INSP
ADJ
Publicité
Table des Matières
