Yamaha FX Nytro 2008 Manuel D'atelier page 492

5 1 3
6 2 4
CRANKCASE
5. Tighten:
• Crankcase bolts (M9 × 105 mm) 1 ~ 8
NOTE:
Tighten the bolts in the order of the embossed
7
numbers on the crankcase.
8
• Tighten the crankcase bolts.
Crankcase bolt 1 ~ 8:
• Loosen and retighten the crankcase bolts.
Crankcase bolt 1 ~ 8:
• Tighten the crankcase bolts further to reach
the specified angle 65 ~ 70°.
Crankcase bolt 1 ~ 8:
WARNING
If the bolt is tightened more than the specified
angle, do not loosen the bolt and then retighten
it. Instead, replace the bolt with a new one and
perform the procedure again.
CAUTION:
• Do not use a torque wrench to tighten the bolt
to the specified angle.
• Tighten the bolt until it is at the specified
angle.
NOTE:
On a hexagonal bolt, note that the angle from one
corner to another is 60°.
5-55
ENG
1st:
15 Nm (1.5 m · kg, 11 ft · lb)
2nd:
15 Nm (1.5 m · kg, 11 ft · lb)
Final:
Specified angle 65 ~ 70°