Yamaha FX Nytro 2008 Manuel D'atelier page 224

a
b
a
1
8. Install:
• Handlebar 1
• Handlebar holders 2
NOTE:
• The handlebar holders should be installed with
the punch marks a facing forward.
• Align the punch mark b on the handlebar with
1
the upper surface of the lower handlebar holder.
2
(FX10)
• Align the punch mark b on the handlebar with
the upper surface of the steering joint. (FX10RT/
FX10RTR/FX10RTRA/FX10MT/FX10MTR/
FX10MTRA)
CAUTION:
First, tighten the bolts on the front side of the
handlebar holder, and then on the rear side.
9. Install:
1
For FX10/FX10RT/FX10RTR/FX10RTRA
• Wind deflector bracket holder 1
2
• Wind deflector bracket 2
NOTE:
Align the end of the wind deflector bracket with the
punch mark a on the handlebar.
10. Install:
• Handlebar
NOTE:
Install the handlebar cover 1, making sure not to
pinch the cables, leads, etc.
11. Adjust:
• Throttle cable free play
Refer to "THROTTLE CABLE FREE PLAY
ADJUSTMENT" in CHAPTER 2.
3-15
CHAS
STEERING
Handlebar holder bolt:
23 Nm (2.3 m · kg, 17 ft · lb)
protector 1
FX10RTR/FX10RTRA/FX10MTRA)
(FX10/FX10RT/