Ignition Coil - Yamaha FX Nytro 2008 Manuel D'atelier

È
É
IGNITION SYSTEM
IGNITION SPARK GAP
The following procedure applies to all of the ignition
coils.
1. Measure:
• Ignition spark gap
Out of specification → Replace the ignition
coil(s).
Measurement steps:
• Disconnect the ignition coil 1 from the spark
plug.
• Connect the opama pet-4000 spark checker 2
or ignition checker 3.
Opama pet-4000 spark checker:
YM-34487
Ignition checker:
90890-06754
• Measure the ignition spark gap a.
• Crank the engine by setting the engine stop
switch to "RUN" and turning the main switch to
start and gradually increase the spark gap until
a misfire occurs.
Ignition spark gap:
6.0 mm (0.24 in)
È For USA/Canada
É For Europe

IGNITION COIL

The following procedure applies to all of the ignition
coils.
1. Disconnect:
• Ignition coil coupler
2. Connect:
• Pocket tester
(to the ignition coil)
3. Measure:
• Primary coil resistance a
• Secondary coil resistance b
Out of specification → Replace the ignition
coil(s).
Primary coil resistance:
1.19 ~ 1.61 Ω at 20 °C (68 °F)
Secondary coil resistance:
8.5 ~ 11.5 kΩ at 20 °C (68 °F)
8-5
– +
ELEC