Warranty - Altrad Belle BMD 300 Manuel De L'opérateur

GB
Note: Remove all Oil and Fuel before tipping the machine over.
Belt Removal (On Machines From Serial No. 141779)
1. Remove the 6 x M8 Bolts from the Sump Guard and then remove the Sump
Guard from the machine.
2. Remove 4 X Bolts (A). This will allow you to remove the Belt (B).
NOTE:- Ensure the Belt is removed from the Engine pulley (D) rst.
Belt Fitting (On Machines From Serial No. 141779)
1. Place the Belt (B) onto the transmission pulley (C), and then onto the engine
pulley (D).
2. Ensure the Belt (B) runs on the outside of the Clutch Tensioning Arm.
(See the diagram on the right to see the route of the Belt (B))
3. Add Bolt (A) to the Clutch Tensioning Arm and tighten so that the arm
is 235mm from the Cross Plate (See the diagram on the right).
If adjustment is required, tweak the 2 Nuts (E) until correct distance is achieved.
4. Attach the Sump Guard using the 6 x M8 Bolts to a torque setting of 28Nm.
GB
Your new Belle Group 'BMD' Minidumper is warranted to the original purchaser for a period of one-year (12 months) from the original
date of purchase. The Belle Group warranty is against defects in design, materials and workmanship.
The following are not covered under the Belle Group warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Belle Group or their recognised agents.
3. Transportation or shipment costs to and from Belle Group or their recognised agents, for repair or assessment against a
warranty claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
· Drivebelt/s
· Engine air lter
· Engine spark plug
Belle Group and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other
damages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should rstly be directed to Belle Group, either by telephone, by Fax, by Email, or in writing.
For warranty claims:
Tel: +44 (0)1298 84606
Write to:
Belle Group Warranty Department,
Sheen, Nr. Buxton
Derbyshire,
SK17 0EU
England.
Service and Maintenance

Warranty

Fax: +44 (0)1298 84722 Email : warranty@belle-group.co.uk
14
A
C
A
A
B
A
E
D
235mm
E