Unpacking & Assembly - Viking Range 5 Série Utilisation Et Entretien

UNPACKING & ASSEMBLY
The grill arrives nearly ready to use and requires only minor
assembly.
By carefully following the uncrating and unpacking steps,
you will improve your fi rst experience with the grill.
Shipping weight on smaller units is app. 300 pounds and
larger units may weigh over 500 pounds.
WARNING:
EXCESSIVE WEIGHT HAZARD!
Use two or more people to move or install this
unit. Failure to follow this instruction can result in
back or other personal injuries.
CRATE & CARTON
• IMPORTANT! Do not remove staples around the top of
the carton. These staples hold a wooden pallet in place
inside the carton that protects the unit from damage.
Removing these staples may cause the pallet to fall on
the top of grill.
How to Remove the Carton
• Cut the main strap holding the grill to the pallet.
• Remove the staples at the bottom of the carton.
• Lift off the carton.
• With assistance, remove the grill from the pallet and
place into desired location.
The wheels sit down in the gaps of the shipping crate so
that the grill can sit safely and solidly on the crate during
shipping. The grill cannot be slid directly off of the pallet.
One way to safely move the grill off of the pallet is by lifting
one end of the grill high enough to place a ramp under the
wheel and then lift the
other end while rolling
the grill off of the pallet.
|
14 INSTALLATION / USE & CARE
Grill will not
slide directly
off pallet.
CARE
INTERIOR PACKING
Viking Range, LLC uses sturdy tie-down cables and straps
to ensure your grill arrives at your home in the same condi-
tion that it left our factory. BE SURE YOU HAVE REMOVED
ALL TIE DOWNS BEFORE USING YOUR GRILL.
• Remove the white accessory box and wood packing, the
grill racks, and remove any loose items from the fi rebox.
• Carefully cut the cable ties securing the warming rack and
rotisserie spit (if equipped).
• Cut the strapping that secures the briquette trays and
carefully lift them out, front fi rst.
Make sure you remember to remove the tie-downs on the
burners.
• On ProSear™ models, cut and remove ties from the
burner partition on the left side of the ProSear™ burner.
• Ensure that all burners are properly seated on the burner
valve orifi ce and sitting level with the legs in the frame
slots and no side-to-side movement.