Memorising Transmitters Or The Keypad In Mode 1; Selecting The Command To Be Associated With Your Key - Nice Home Filo Notice Simplifiee

4

MEMORISING TRANSMITTERS OR THE KEYPAD IN MODE 1

Using this programming mode, you can programme all the buttons of
the transmitter or keypad on this automation with the following functions:
T1: Open / Stop / Close function
T2: Pedestrian Opening / Stop / Closing function
T3: Opening / Stop function
T4: Close / Stop function
T5: light with ON / OFF function
Procedure for programming the transmitter:
01. Press button P4 (on the control unit) for at least 3 seconds.
02. Release the button when LED L4 lights up.
03. Within 10 seconds, press any button of the transmitter to be
memorised for at least 3 seconds: LED L4 must flash 3 times.
04. Wait 10 seconds for the transmitter's memorisation.
Procedure for programming the DS100 keypad:
01. Press button P4 for at least 3 seconds.
02. Release the button when LED L4 lights up.
03. Within 10 seconds, enter code 11 (or a new code) on the keypad
and press button B on the keypad for 4 seconds: LED A must flash
3 times.
04. Wait 10 seconds and the code's keypad will be memorised
The code can be personalised by performing procedure 6, which can be
found in the keypad's instructions.
5
MEMORISING TRANSMITTERS OR THE KEYPAD IN MODE 2
Using this programming mode, you will programme a single button of the transmitter or keypad on this automation by associating one of the desired
commands listed in the table below.
Number of button presses Associated command
once
2 times
3 times
4 times
5 times
5.1 - SELECTING THE COMMAND TO BE ASSOCIATED
WITH YOUR KEY
01. Press button P4 for a number of times corresponding to the chosen
command. LED P4 will flash a number of times equal to the desired
function.
02. Within 10 seconds, press the button of the transmitter you wish to
associate with this function for at least 3 seconds. LED L4 should
flash 3 times.
03. Wait 10 seconds and the transmitter will be memorised.
6 – English
TABLE 2 - Command memorisation
Step-by-step
Pedestrian opening
Pedestrian
Closing
Light output (device) 230 V: ON-OFF
T1
A
B
T3
C
Aerial
L4 L4
P4
P4 P4
3 s
Number of flashes of LED L4 on the
control unit
1
2
3
4
5
Aerial
L4 L4
P4
P4 P4
LED 20
T5
T2
T4
Flash Flash
Fuse 1.6A T Fuse 1.6A T
OGI OGI
ECSbus ECSbus
21
Stop Stop
SbS SbS
L3 L3
L4 L3 L L 3 3 L2 L2 L1 L1
SbS SbS
P 3 P3 P 3 3 P2 P2 P1 P1
P3 P3
Flash Flash
Fuse 1.6A T Fuse 1.6A T
OGI OGI
ECSbus ECSbus
22
Stop Stop
SbS SbS
L3 L3
L4 L 3 L L3 3 L2 L2 L1 L1
SbS SbS
P P 3 P3 3 3 P2 P2 P1 P1
P3 P3