Limit Switch Adjustment; Installation Of Various Devices; Electrical Connections - Nice Ten TN2010 Instructions Et Recommandations Pour L'installateur

3.3) Limit switch adjustment

Ten 2010 is not fitted with mechanical limiters, but is equipped with an electronic system for absolute limitswitch. For settings, refer to para-
graph "4.3 Learning the door opening and closing positions."

3.4) Installation of various devices

Install the other devices envisaged as stated in the respective instructions. Refer to paragraph"3.5 Description of electrical connections "and
figure 17 for devices that can be connected to TEN

3.5) Electrical connections

!
All electrical connections must be made with the system disconnected from the power supply.
1. To proceed with electrical connections, loosen the screws of the cover (Figure 15)
2. Remove the two rubber membranes closing off the two cable routing holes. Cut a hole in the membrane and insert the power cable
through the membrane and right-hand hole. Cut a hole in the membrane and pass the other cables to the various devices through the
membrane and left-hand hole. Leave a cable length of 20÷30 cm longer than necessary. See table 6 for the cable types.
3. Connect the mains power cable directly to terminals 1(phase) and 2 (neutral), and 3 (earth); secure the cable with the collar as shown in
Figure 16
4. Make connections of the other cables as shown in the diagram of Figure 17. The terminals are removable to facilitate these operations.
5. On completion of connection, collect and secure the cables by means of clips (Figure 18).
15
17
10
16 18