Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
8
1. On/Off switch
2. Overload indicator
3. Voltage regulator
4. Wire feed control
5. Torch connection
6. Inching
7. Gas connection
8. Grounding
Overload/Fault LED indicator:
The indicator lights in the following two situations:
a) If the machine has malfunctioned and can not be operated.
b) If the cutting device has exceeded the standard working time the protection mode
is initiated and the machine will stop functioning. This means that the machine is
now being cooled in order to be able to restore temperature control again after the
device has overheated. Therefore the machine is stopped. During this process, the red
warning light on the front panel lights up. In this case it is not necessary to remove
the power plug from the socket. The ventilation system may be left on in order to
enhance the cooling of the machine. When the red light goes dark, this means that
the temperature is now down to the normal level and the unit can be put back into
operation.
44
EN
SMIG 250 P
4
2
3
1
6
5
Accessories for S-MIG 250 P
1
4
1. Mask
2. Hose bundle
3. Grounding clamp cable
4. Slag hammer
Technical details:
Article
SMIG-250P
Condition
New
AC Frequency (Hz)
50/60
Input voltage (V)
230 V 1-phase
Open circuit voltage (V)
42
Adjustable welding current (A)
50-250
Performance (%)
60%
Weight (KG)
16 kg
Dimensions (mm)
420x220x390
Protection class
IP21
Wire
0.8 mm - 1 mm
Insulation class
B
Wire coil diameter
20cm
Wire diameter
0.6/0.8 mm
Type
Inverter
The device uses a 1-phase connection (230V +/- 10%).
1 PH
EN
2
3
45
45
Publicité
Table des Matières
