Specific Safety Rules - STAMOS S-MIG 250 Manuel D'utilisation

Service
1. Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in a risk of
injury.
2. When servicing a tool, use only identical replacement parts. Use of
unauthorized parts or failure to follow maintenance instructions may create a risk of
electric shock or injury.

SPECIFIC SAFETY RULES

1. Maintain labels and nameplates on the tool. These carry important in-
formation. If unreadable or missing, contact our service team for a replacement.
2. Always wear the approved safety impact eye goggles and heavy
work gloves when suing the tool. Using personal safety devices reduce the risk
for injury. Safety impact eye goggles and heavy work gloves are available from Harbor
Freight Tools.
3. Maintain a safe working environment. Keep the work area well lit. Make
sure there is adequate surrounding workspace. Always keep the work area free of obst-
ructions, grease, oil, trash, and other debris. Do not use a power tool in areas near flam-
mable chemicals, dusts, and vapors. Do not use this product in a damp or wet location.
4. Avoid unintentional starting. Make sure you are prepared to begin work
before turning on the tool.
5. Never leave the tool unattended when it is plugged into an elec-
trical outlet. Turn off the tool, and unplug it from its electrical outlet before leaving.
6. Always unplug the tool from its electrical outlet before performing
and inspection, maintenance, or cleaning procedures.
7. Prevent eye injury and burns. Wearing and using the approved personal
safety clothing and safety devices reduce the risk for injury.
a. Wear the approved safety impact eye goggles with a welding helmet fea-
turing at least a number 10 shade lens rating.
32
EN
b. Leather leggings, fire resistant shoes or boots should be worn when using
this product. Do not wear pants with cuffs, shirts with open pockets, or any
clothing that can catch and hold molten metal or sparks.
c. Keep clothing free of grease, oil, solvents, or any flammable substances.
Wear dry, insulating gloves and protective clothing.
d. Wear an approved head covering to protect the head and neck. Use
aprons, cape, sleeves, shoulder covers, and bibs designed and approved for
welding and cutting procedures.
e. When welding/cutting overhead or in confined spaces, wear flame resis
tant ear plugs or ear muffs to keep sparks out of ears.
8. Prevent accidental fires. Remove any combustible material from the work
area.
a. When possible, move the work to a location well away from combustible;
protect the combustibles with a cover made of fire resistant material.
b. Remove or make safe all combustible materials for a radius of 35 feet (10
meters) around the work area. Use a fire resistant material to cover or
block all open doorways, windows, cracks, and other openings.
c. Enclose the work area with portable fire resistant screens. Protect com
bustible walls, ceilings, floors, etc., from sparks and heat with fire resistant
covers.
d. If working on a metal wall, ceiling, etc., prevent ignition of combustibles on
the other side by mobbing the combustibles to a safe location. If relocation
of combustibles is not possible, designate someone to serve as a fire watch,
equipped with a fire extinguisher, during the welding process and for at least
one half hour after the welding is completed.
e. Do not weld or cut on materials having a combustible coating or combus
tible internal structure, as in walls or ceilings, without an approved method
for eliminating the hazard.
EN
33 33