Accessories - STAMOS S-MIG 250 Manuel D'utilisation

Power supply for S-MIG250
HIGH POWER = These devices use a 3-phase
connection (380V +/- 10%).
3 PH
The yellow-green wire is used as a PE protective wire
connector. The three phases (black) can be freely con-
nected to L1, L2 and L3 en (please have it done only
by a qualified electrician)

Accessories

1
2
3
4
48
EN
1
2
3
1. Mask
2. Hose bundle
3. Grounding clamp cable
4. Slag hammer
Article S-MIG 250
Condition New
Ignition Contact
Model input voltage (V) 380 V 3-phase
Adjustable welding current (A) 20-250
Duty cycle at 250A 60%
Duty cycle at 194A 100%
Weight (kg) 41
Dimensions (mm) 640x300x610
Protection class IP21
Insulation class B
Wire coil diameter max. 27 cm
Wire diameter 0.8/1mm
Information about the S-MIG 250
A device made by Stamos Germany: from the wire feed assembly with 4 metal rolls
right through to the cart with practical storage space for welding equipment to
ensure easy transport of the device, everything was considered. Easy operation and
excellent thin metal sheet processing properties - these are the advantages of MIG-
MAG welding which uses different gases, depending on the material.
Therefore using MIG (metal inert gas) enables the processing of aluminium and alumi-
nium alloys, while the MAG (metal active gas) is meant for construction steel, boiler
steel and steel pipes from about 0.5 mm and for stainless steel and highly alloyed
steels.
EN
49 49