Battery Replacement - GYS STARTPACK TRUCK Mode D'emploi

Masquer les pouces Voir aussi pour STARTPACK TRUCK:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Translation of the original instructions

BATTERY REPLACEMENT

-
1
Product
Battery
STARTPACK TRUCK
6FM - 20
Whichever mode the STARTPACK TRUCK is being used for (12V or 24V), replace both batteries at the
same time.
To replace the batteries :
First the back panel must be unscrewed (18 screws) and removed.
Once the back panel is removed, the batteries are visible, with one in front of the other (cf illustration). Terminal -
on the left, terminal + on the right.
The battery is connected to the STARTPACK at two points : at the - terminal and at the + terminal. To remove the
battery, remove the screws that enable the connection between the battery and the STARTPACK at the terminals
+ 1 and - 2 . (Once the first battery is removed, it is possible to remove the second one from the machine's
end)
Once the first battery is removed, make sure to insulate the terminals to prevent any
short-circuit. Then remove the second battery.
When putting new batteries, make sure to observe the polarities of both the battery and
the STARTPACK TRUCK. Terminal - on the left, terminal + on the right (cf illustration).
Put the 4 screws and washers back, tighten the nuts (recommended torque wrench 4
N.m).
Place the booster's backpanel screws back on.
STARTPACK TRUCK
Type
Voltage (V)
Lead- acid battery
2 x 12
Dimensions
Capacity (Ah)
(cm)
2 x 22
38,9 x 22,5 x 50
EN
+
2
Battery ref
53151
13

Publicité

Table des Matières
loading

Table des Matières