Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Translation of the original instructions

BATTERY REPLACEMENT :

1
Product
Battery
GYSPACK PRO
6FM-22
To replace the battery :
The booster must be disconnected form the power supply.
First the back panel must be unscrewed (14 screws) and removed.
Once the back panel is removed, the battery front appears (cf illustration). The battery is connected to the GYSPACK
PRO at two points : at the - terminal - 1 and at the + terminal 2 . To remove the battery, remove the 2 screws
that enable the connection between the battery and the GYSPACK PRO at the terminals + and -.
When putting a new battery, make sure to observe the polarities of both the battery and
the GYSPACK PRO. Terminal - on the left, terminal + on the right (cf illustration). Put the 2
screws and washers back, tighten the nuts (recommended torque wrench 4 N.m).
Place the booster's backpanel screws back on.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSPACK PRO
Type
Voltage (V)
Lead- acid battery
12
Capacity (Ah)
Dimensions (cm)
22
34 x 20 x43
EN
2
Battery ref
53151
13

Publicité

Table des Matières
loading

Table des Matières