Led Light - GYS STARTPACK TRUCK Mode D'emploi

Translation of the original instructions
• Put the switch to 12V or 24V position according to the vehicle to start.
• Go to the driver's seat and turn the ignition key ( 6 sec max). If your engine does not start, wait 3
minutes until next attempt.
• Position the switch «OFF».
- Risk of explosion or acid splashes when connecting a 12V booster on a 24V vehi-
cle (or a 24V booster on a 12V vehicle).
- Beware of possible short-circuit of the clamps.
• After use, when the battery negative terminal is connected to the vehicle chassis:
- Turn the switch to OFF (if any), disconnect the charger from the mains then disconnect the
black clamp and finally the red clamp.
• When the battery positive terminal is connected to the chassis, in this case:
- Turn the switch to OFF (if any), then disconnect the red clamp and finally the black clamp.
• Recharge your Startpack after use. (see 'Charging internal battery')
USE AS A 12V DC POWER SUPPLY
The cigarette lighter plug is protected by an integrated 20 A circuit breaker. In the event of an
overheating due to an overcharge, the circuit breaker will stop the power supply.
This device can be used as a 12V DC power supply for many electrical debices such as radio, fan, electrical tools, camera,
TV...
• Turn the knob to the OFF position.
• Plug the cigarette lighter socket of your electrical device in the Booster (cable not included).
• Turn the switch onto the 12V position.
The output is protected by a 20A thermal circuit-breaker.
Estimated autonomy of STARTPACK TRUCK as a 12 V DC power supply
Device
Fluorescent cellular light
Radio, Fan, Echoprobe
Videocamera, light spot
Power tool, drying pump
Air Compressor, Car vaccum cleaner

LED LIGHT

This device has an integrated light comprised of 7 powerful LED.
PROTECTION
This device is designed with many protection features :
• ON/OFF switch to protect against overvoltage when connecting.
• An alarm beep in case of reversed polarity and misuse.
• Copper cable 2 x 1.80m, ø 25mm² with 600A insulated clamps.
• 300A fuse located on the plastic case. A replacement duse is located at the back of the device (ref. 054561).
STARTPACK TRUCK
The cables must not be pinched or in contact with hot or sharp surfaces.
- If the cooling period between each attempt (3 minutes) is not observed or if the duration
of the attempt is too long (> 6 seconds), the chances of a successful jumpstart are signi-
ficantly reduced (risk of power loss).
- Risk of battery acid leaks or damage if the recommended periods are not observed.
- If the vehicle does not start, it may be a problem other than a faulty battery: alternator,
glowplug...
Estimated consumption (in watts)
4
9
15
24
80
Estimated automomy (in hours)
69
30
18
11
3
EN
11