Cigare Lighter Socket; No Warranty For The Battery; Protections; Advices And Warnings - GYS 610 Manuel D'utilisation

Cigar lighter socket
• It can be used for the following uses :
▪ To connect a portable lamp (fusible 15.A)
▪ To maintain and save the memories of the vehicle. Warning : check before that the
consumption does not exceed the fuse gauge (risk of cables heating)
It is forbidden to reload the booster using the cigar lighter socket. It must be used only for very low
consumptions.

No warranty for the battery

Gyspack contains a high performance battery, which has to be reloaded after each use. If this
condition is not respected, within 24 h the battery faces a major discharge and get sulphated. This
cause the deterioration of the battey.
For this reason, the battery of the Gyspack, which is expensive, is not under warranty.

Protections

Your product has been developed with a maximum of protections.
• The grips of starting are insulated.
•
Thermal protection: the battery transformer of the product is protected by a thermal switch
(cooling: about ¼ h).

Advices and warnings

• choose a sheltered room with appropriate airing.
• Reload the gyspack in an aired place and avoid to make sparks.
• The charger must be installed so that the mains plug is accessible.
• Check regularly the GYSPACK, specially the power cord, the plug and the case, to detect any
damage. If the GYSAPCK is damaged, it must not be used before reparation.
• In case the power cord is damaged is damaged, be sure to stop using it at once. Sent it to nearby
appoint repair center that is authorized by manufacturer in order to avoid any danger.
• Do not open the product. All modification or attempt of modification not done by a technician of
GYS can lead to the cancellation of the warranty of the product and of the responsibility of the
firm GYS on this product.
•
Separate collection required - Do not throw in a domestic dustbin.
• The machine is delivered with a socket type CEE 7/7.
•
It must be connected to a ground socket 230 V.
Declaration of conformity of the autonomous stater GYSPACK
The company GYS certifies that the charger used in the machine :
GYSPACK 610 – 810
is manufactured in compliance with the requirements of the following European directives :
- Low Voltage Directive : 73/23/EEC - 19/02/1973 (amended by 93/68/EEC)
- EMC Directive : 89/336/EEC - 03/05/1989 (amended by 92/31/EEC, 93/68/EEC,
91/263/EEC),
He is therefore comply with the following harmonized standards :
- EN60335-2-29
- EN55014.
The appliance is CE/GS-marked : June 2007.
01/07/06
Société GYS
134 BD des Loges
53941 Saint Berthevin
GYSPACK 610 - 810
Nicolas BOUYGUES
Président Directeur Général/ CEO
5