Log Placement - Napoleon IR3N-1 Instructions D'installation Et D'utilisation

Masquer les pouces Voir aussi pour IR3N-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PHAZER
logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that
TM
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
LOG SUPPORT
A. Place the rear log behind the left
and right log supports and ensure
that it's tight to the burner. Make
sure to centre the pilot in the notch.
Adjust the log supports tight to the
log to hold it in an upright position.
D. Position the left charcoal strip
in front of the left middle log, lining
up the holes in the bottom with the
2 front left studs.
G. Position a pin into the right side
hole of the rear log, move the right
crossover log into position, lining
up the top hole with the pin in the
rear log.
WARNING
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
B. Place the left middle log into
position, lining up the two holes in
the bottom with the studs located
on the left side of the burner.
E. Position the right charcoal strip
in front of the right middle log,
lining up the holes in the bottom
with the 2 front right studs.
76.1A
C. Place the right middle log into
position, lining up the two holes in
the bottom with the studs located
on the right side of the burner.
F. Position a pin (supplied) into the
left side hole of the rear log, move
the left crossover log into position,
lining up the top hole with the pin
in the rear log.
W415-1342 / A / 03.08.17
13
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ir3p-1

Table des Matières