6.2
OPERATION
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
6.2.1
GENERAL REMOTE TRANSMITTER LAYOUT
TIMER DISPLAY
ON/OFF
TEMPERATURE
SETTING
SET BUTTON
OFF BUTTON
6.2.2
PROGRAMMING
Press and hold the receiver's reset button until you hear two beeps. (First beep is short, second beep
A.
is long.) Release the button after the second beep, refer to "INSTALLATION OVERVIEW" for receiver
location.
Within the subsequent 20 seconds press and hold the small flame button
B.
until you hear two additional short beeps confirming the code is set, refer to "GENERAL REMOTE
TRANSMITTER LAYOUT". (NOTE: One long beep indicates the sequence has failed or wiring is
incorrect).
NOTE: This is a one time setting only, and is not required after changing the batteries of the remote transmitter
or receiver.
WARNING
!
THE GLASS DOOR OPENED OR REMOVED.
TEMPERATURE
DISPLAY
SIGNAL INDICTOR
F
C
:
P1
P2
MANTEMPTIMER
LOW BATTERY
INDICTOR
am
TIME DISPLAY
pm
MODES OF
OPERATION
LARGE FLAME BUTTON
SMALL FLAME BUTTON
on the remote transmitter
17
EN
W415-1342 / A / 03.08.17