Setting The Time; Setting The Timer Function; Flame Height; Low Battery - Napoleon IR3N-1 Instructions D'installation Et D'utilisation

To set Nighttime Temperature Mode quickly press the SET button, scrolling to the desired mode, then
C.
hold the SET button untill the "TEMP" on the display flashes.
D. To increase the Nighttime Temperature press the large flame button
Temperature press the small flame button . To use this setting as the new temperature press the OFF
button.
NOTE: When in regular operation the remote will always show the room temperature. Thermostat
function adjusts the flame height according to the difference between the set temperature and the
actual room temperature; as the room temperature gets closer to the set point it will adjust the flame
down.

6.2.7 SETTING THE TIME

NOTE: Time display will flash upon battery installation or when the large and small flame buttons are
pressed simultaneously.
A. To set the hour press the large flame button
To set the minutes press the small flame button .
B.
Press the "OFF" button to set the time.
C.

6.2.8 SETTING THE TIMER FUNCTION

To set the Timer Mode quickly press the SET button, scrolling to the desired mode.
A.
To scroll through P1
B.
Once the desired timer function is shown on the display and the time flashes, press the large flame
C.
button
button to set the time.
NOTE: The default setting for the Timer Function is as follows: P1
11:50am and P2 11:50pm, refer to "GENERAL REMOTE TRANSMITTER LAYOUT".
6.2.9

FLAME HEIGHT

Using the remote transmitter you may set the flame directly to the "HI" setting by double clicking the
A.
large flame button
flame button
Using the remote transmitter you may set the flame directly to the "LO" setting by double clicking the
B.
small flame button . Decrease the flame height can also be done by pressing and holding the small
flame button .
NOTE: For fine adjustment tap the large flame button
transmitter. If the small flame button is held too long the main burner will turn off.

6.2.10 LOW BATTERY

Frequent beeping for 3 seconds when the appliance turns on indicates low battery on the
A.
remote receiver. The battery pack is located on the bottom right side of the appliance, refer to
"INSTALLATION OVERVIEW" for location.
Low battery indicator is in the top right corner of the remote, we also recommend replacing the
B.
batteries every two years.
NOTE: When low battery occurs the appliance will shut down. The appliance will shut off if no change
has occurred to the flame height or the appliance has not turned on for a period of 5 days.
,P2 briefly press the set button.
, P1 , P2
to adjust the hour and the small flame button
. Increasing the flame height can also be done by pressing and holding the large
.
. To decrease the Nighttime
.
to adjust the minutes. Press the "OFF"
6:00am and P2 8:00pm, P2
or small flame button
19
when using the remote
W415-1342 / A / 03.08.17
EN