Burner Removal; Valve Train Access - Napoleon IR3N-1 Instructions D'installation Et D'utilisation

24
8.5

BURNER REMOVAL

Remove the glass door, see "DOOR REMOVAL AND INSTALLATION" section.
A.
EN
Remove the logs, see "FINISHING" section.
B.
Remove the 5 screws that secure the log support in place. Lift the support out, refer to Figure 1.
C.
Remove the 4 screws that secure the front burner support in place, refer to Figure 2. Lift the burner
D.
up and out.
FIGURE 1
8.6

VALVE TRAIN ACCESS

A. Remove the glass door. See "DOOR REMOVAL AND INSTALLATION" section. Remove the burner,
see "BURNER REMOVAL" section.
Remove the 14 screws holding the valve train in place.
B.
NOTE: A new gasket may be required when reinstalling the valve train assembly. Contact your
local authorized dealer/distributor.
Carefully lift the valve train assembly out far enough to access the manual shut off valve and turn to the
C.
off position. Disconnect the flex connector from the valve. Ensure all other wires are disconnected for
easy removal of the valve train, lift the valve train out of the appliance.
W415-1342 / A / 03.08.17
FIGURE 2