Turning "On" The Appliance; Turning "Off" The Appliance; Hand Held Remote Transmitter Operations; Temperature Display - Napoleon IR3N-1 Instructions D'installation Et D'utilisation

18
6.2.3

TURNING "ON" THE APPLIANCE

Place the "ON/OFF" switch in the "ON" position by the receiver, refer to "INSTALLATION OVERVIEW"
A.
for location.
EN
Using the remote transmitter simultaneously press the large flame button
B.
you hear a short beep, this confirms the start of the appliance, you can then release both buttons.
(The ignition process has begun once continuous beeping has begun).
Wait several seconds for the appliance to ignite. After main ignition the remote will default to the
C.
Daytime Temperature Mode
NOTE: Refer to "GENERAL REMOTE TRANSMITTER LAYOUT".
6.2.4

TURNING "OFF" THE APPLIANCE

Using the remote transmitter press the "OFF" button.
A.
NOTE: To turn the appliance on after pressing the "OFF" button, you must wait 30 seconds for both
burners to turn off. The appliance will shut off if no change has occured to the flame height or if the
appliance has not turned on for a period of 5 days.
6.2.5

HAND HELD REMOTE TRANSMITTER OPERATIONS

Press the "Set" button to change modes.
A.
B. The modes change in the following order:
NOTE: Refer to "GENERAL REMOTE TRANSMITTER LAYOUT".
MAN
•
•
•
•
6.2.6

TEMPERATURE DISPLAY

NOTE: Press the "OFF" button and the small flame button
display changes from Fahrenheit to Celsius, and vice versa. When changing from Fahrenheit to Celsius
the clock will change from a 12 hour to 24 hour clock, refer to "GENERAL REMOTE TRANSMITTER
LAYOUT".
To set Daytime Temperature Mode quickly press the SET button, scrolling to the desired mode, then
A.
hold the SET button until the "TEMP" on the display flashes.
To increase the Daytime Temperature press the large flame button
B.
Temperature press the small flame button . To use this setting as the new temperature press the OFF
button.
W415-1342 / A / 03.08.17
TEMP
TEMP TEMP
For flame height adjustment in Manual Mode
to increase to the highest flame height. Double click the small flame button
the lowest flame height. Press the large flame button
to decrease flame height. NOTE: Holding the small flame button for too
flame button
long will switch the appliance to pilot mode. To turn the appliance off completely press
the "OFF" button.
For Daytime Temperature Mode
ignited). The default temperature setting for this mode is 23°C / 74°F. (Daytime Temperature
mode is set by comparing the set temperature and room temperature, the flame height is then
adjusted automatically to achieve this Daytime Temperature setting.)
For Nighttime Temperature Mode
ignited). (Nighttime Temperature mode is set by comparing the night time set temperature and
room temperature, the flame height is then adjusted automatically to achieve this Nighttime
Temperature setting.)
TIMER
Timer Mode the appliance must be set to standby mode (pilot ignited). There are two
timer settings available (P1 and P2) allowing the appliance turn off and to turn on at specified
times. NOTE: The "TIMER DISPLAY" indicates the set temperature every 30 seconds.
.
TIMER MAN
MAN
double click the large flame button
TEMP
the appliance must be set to standby mode (pilot
TEMP
the appliance must be set to standby mode (pilot
simultaneously until the temperature
and the OFF button until
to decrease to
to increase flame height or the small
. To decrease the Daytime