Electrical Information; Wiring Diagram - Napoleon IR3N-1 Instructions D'installation Et D'utilisation

Masquer les pouces Voir aussi pour IR3N-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.0 ELECTRICAL INFORMATION

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN
ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT,
5.1

WIRING DIAGRAM

This appliance comes equipped with a battery pack. Install 4 AA batteries into the holder that is connected to
the wire harness. Place near the front of the appliance for ease of changing batteries.
THERMOCOUPLE
WIRE
ELECTRICAL CIRCUIT.
THE UNITED STATES.
WITH THE GLASS DOOR OPENED OR REMOVED.
PSE PILOT
INTERRUPTER
BLOCK
ORANGE
WARNING
!
GV60 VALVE
BLACK WITH YELLOW TERMINAL END
BLACK WITH
RED TERMINAL END
RECEIVER
RESET BUTTON
15
69.2_2
BLACK
(8 WIRE)
OFF ON
BATTERY
HOUSING
W415-1342 / A / 03.08.17
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ir3p-1

Table des Matières