Propane Conversion - Napoleon IR3N-1 Instructions D'installation Et D'utilisation

7.4

PROPANE CONVERSION

Turn off the gas supply to the appliance.
A.
Remove the front then the door from the appliance by
B.
releasing the top two door latches, tilt the door forward and
lift from slots.
Remove the logs and panels from the appliance.
C.
Remove the log support from the appliance by removing the
D.
5 screws that secure it in place, refer to Figure 1.
Remove the burner from the appliance by removing the 4
E.
screws that secure it in place, refer to Figure 2.
Remove the main burner orifice and replace with the orifice
F.
supplied in the manual baggie. (Use pipe thread compound).
Adjust the air shutter opening to 1/16" for Natural Gas or 3/8"
G.
for Propane.
To convert the main valve to the desired fuel, remove the
H.
conversion plug using a screwdriver. Remove the plastic tip
on the plug stem and rotate 180 degrees, refer to Figure 3.
Re-secure the plastic tip to the stem plug (it will click into
place). Reinstall the conversion plug into the valve.
Remove the min. rate screw and replace with the one
I.
supplied.
NOTE: The min. rate screw, conversion plug and conversion tab
locations are illustrated in Figures 4 & 5.
Loosen the pilot hood by turning counter clockwise with a wrench until the conversion tab slides easily.
J.
Slide the tab to view the label of the fuel desired, the tab is marked with NAT and LP Tighten the pilot
hood back to original position, do not overtighten!
Reinstall the burner and log support.
K.
The conversion data label, found in the manual baggie, it must be filled out and attached adjacent to the
L.
valve.
Turn on the gas supply and check for gas leaks by brushing on a soap and water solution. Do not use
M.
open flame.
Light the pilot and main burner to ensure that the gas lines have been purged. Refer to the "OPERATING
N.
AND LIGHTING INSTRUCTIONS" section of the instruction manual.
O. Once all systems have been checked, replace the panels and log media.
Re-secure the door then reinstall the front.
P.
FIG. 4
THERMOCOUPLE
PILOT
HOOD
MIN. RATE
SCREW
CONVERSION
TAB (NAT./LP)
THERMOCOUPLE
CAPUCHON DE
VIS DE
LA VEILLEUSE
TAUX MIN.
FIG. 1
CONVERSION PLUG
CONVERSION PLUG
CONVERSION PLUG
FIG. 2
FIG. 3
Diagrams courtesy of Maxitrol Company
Diagrams courtesy of Maxitrol Company
Diagrams courtesy of Maxitrol Company
LANGUETTE
LANGUETTE
LANGUETTE
FIG. 5
CONVERSION
PLUG
Diagrams courtesy of Maxitrol Company
Diagrams courtesy of Maxitrol Company
Diagrams courtesy of Maxitrol Company
BOUCHON DE
CONVERSION
21
EN
NG position
NG position
NG position
180°
180°
180°
LP position
LP position
LP position
position GN
position GN
position GN
180°
180°
180°
position PL
position PL
position PL
W415-1342 / A / 03.08.17