Table des Matières
Publicité
CAMSHAFTS
Install the clips and camshaft caps 4.
G
Bolt (camshaft cap):
10 Nm (1.0 m • kg, 7.2 ft • lb)
NOTE:
Tighten the bolts (camshaft cap) 5 in a
crisscross pattern.
CAUTION:
The bolts (camshaft cap) must be tight-
ened evenly, or damage to the cylinder
head, camshaft caps, and camshaft will
result.
2. Install:
Timing chain tensioner
G
Installation steps:
While pressing the tensioner rod lightly
G
with fingers, use a thin screwdriver and
wind the tensioner rod up fully clockwise.
With the rod fully wound and the chain
G
tensioner UP mark a facing upward,
install the gasket 1 and the chain ten-
sioner 2, and tighten the bolt 3 to the
specified torque.
Bolt (timing chain tensioner):
10 Nm (1.0 m • kg, 7.2 ft • lb)
Release the screwdriver, check the ten-
G
sioner rod to come out and tighten the
gasket 4 and the cap bolt 5 to the speci-
fied torque.
Tensioner cap bolt:
7 Nm (0.7 m • kg, 5.1 ft • lb)
3. Turn:
Crankshaft
G
Counterclockwise several turns
4. Check:
Rotor "I" mark
G
Align with the crankcase stationary
pointer.
Camshaft match marks
G
Align with the cylinder head surface.
Out of alignment → Adjust.
4 - 28
ENG
Publicité
Table des Matières
