SICK PAC50 Notice D'instruction page 59

Operating Instructions
5.1 Installation on the mounting rail
The PAC50 pressure switch has an integrated fixing mechanism for installing on a mounting rail according to
DIN EN 60715 – 35 mm x 15 mm/7.5 mm.
To install the PAC50, position the lower fixing guide on the mounting rail (see Figure 7
•
PAC50 up until it locks into place (see Figure 7
To remove the PAC50 from the mounting rail, pull the fixing clip down and tilt the PAC50 up and away from
•
the mounting rail.
1
Figure 7: Installation on the mounting rail
5.2 Installation with a switch panel mounting set
To install in a switch panel, use the switch panel mounting set, which is available as an accessory (see
Figure 8). The maximum switch panel thickness is 5 mm. Figure 9 shows the dimensions of the cut-out
section in the switch panel.
8017612/YSZ4/2016-02-09 | PAC50
Subject to change without notice
5 Installation/Mechanical connection
and ).
2 3
2
3
O p e r a t i n g I n s t r u c t i o n s | S I C K
PAC50
) and tilt the
1
5 9