Interruption Of Sterilization Cycle - Tecno-gaz Europa B evo Mode D'emploi

ENGLISH

8.10 Interruption of sterilization cycle

A sterilization cycle can be voluntarily interrupted by pressing the button
least 2 seconds.
The autoclave will emit a beep, go into decompression and on the display will appear the
message ALLARM 001 (INTERRUPTED CYCLE).
To reset error, maintain pressed simultaneously the buttons below indicated, until the
intervention of an acoustic signal:
B-DOOR
ATTENTION:
You can't reset the allarm if the printer works
If an alarm message is displayed (CODE "A") the cycle is to be
considered aborted: it will be necessary to repeat all the preparation and
sterilization operations.
24
+
B-PUMP
+
B-SELECT
for at
B-START