Power Panels (Pps) Addressing And Installation - Lutron GRAFIK 7000 Guide D'installation Et De Maintenance

Power Panels (PPs):
Addressing and Installation
Each power panel must have a unique address
on the power panel link. Power panels are not
pre-addressed by the factory. For proper
operation, the address of the circuit selector in
the power panel must match the address set in
the eLumen software. Without the unique
address, the processor panel cannot
communicate and download system settings to
the power panel.
Refer to job drawings to see the intended
address of each power panel. Set the address
by manually programming the circuit selector
within each power panel. See instructions
provided with each power panel for the
addressing procedure.
If the job drawings do not include an address,
document the power panel's location and model
number for each address. This information will
be needed to set up the system properly.
See the instructions sent with each individual
power panel for detailed installation and line
voltage wiring instructions.
22 Installation of GRAFIK 5000/6000/7000 System
1 2 3 4 D 5
Data A OK
Power OK
Link Link
A B
1 2 3 4 5
D
S C
ELECT IRCUIT
Circuit
V V
IEW ALUE
S V
ELECT ALUE
Link A
Link B
Value
S V D
ELECT ALUE ISPLAYED
Circuit Level
Load Type
(See Instructions)
Zone Assignment
w/ Circuit Schedule
Zone Assignment
w/ Zone Capture
Low-End Trim
High-End Trim
Address
('Ad' displayed)
Circuit selector used to address power panel
C
D
Data B OK
C D
1
2
3
4
5
TM
R