Maintenance Guide - Lutron GRAFIK 7000 Guide D'installation Et De Maintenance

Maintenance Guide

Lutron products are designed to have
minimal maintenance requirements. For more
information on any product, refer to its
specific installation and maintenance
documentation.
Control Station Devices (CSDs)
Clean front surface with a soft towel
moistened with a mild soap solution (non-
ammonia based). Clean approximately every
six months. Do not spray cleaning solution
directly at any CSD.
Power Panels
Visually inspect installation periodically - keep
air flow clear of obstructions. Power panels
generally need 12 in. (300 mm) of clearance
above, below, and in front of the enclosure.
Lighting Zone Controller Panels
Visually inspect installation periodically - keep
air flow clear of obstructions. Lighting zone
controller panels generally need 12 in. (300
mm) of clearance above, below, and in front
of the enclosure.
Danger! Turn power off before working
on any load. See instructions supplied
with individual power panels.
Warning! When working on any load
(such as rewiring a load), replace the
bypass jumpers to protect the power
panels or lighting zone controller panels
until the load is proven. See appropriate
installation guides for details.
R
Processor Panels
There are no maintenance requirements for
these products. Clean the front cover as
needed.
Other
See instructions supplied with individual
products for any other recommendations for
maintenance.
Danger! Any liquid that enters products
with line (mains) voltage may reach
internal components, cause personal
injury, damage the equipment, and void
the warranty.
Installation of GRAFIK 5000/6000/7000 System 27