Link Wiring - Lutron GRAFIK 7000 Guide D'installation Et De Maintenance

Control Station Devices (CSDs):

Link Wiring

Wire the control station device link to all control station devices as shown below. See instruction sheets
provided with each control station device for location of CSD (wallstation) link connector.
T1 T1 T2 T2 T3 T3 T4 T4 T5 T5 T6 T6
H H H H H H H H H H H H
N N N N N N H H H H
0 0
T1 T1 T2 T2 T3 T3 T4 T4 T5 T5 T6 T6
N N N N N N N N N N N N
I I
Note: Label shown is on the cover of the processor
Processor Panel
(GRAFIK 7000P
assembly. Connectors are located along the bottom
with 6 links shown)
edge of the processor assembly.
Notes
• Follow the job drawings to connect control
station devices to the proper link on the
processor (link A-F)
• It is not necessary to have the processor panel
at the end of the CSD link
• See RS485 Wiring Overview for approved
cable options
• Links A through F can be used as either CSD
or LZC links in a GRAFIK7000 system; function
is defined using eLumen software
R
Link A label
(typical)
1 2 3 4 5 6
1 2 3 4 D
3 4
Control Wiring
(2) #12 AWG
2
(4.0 mm )
1: Common
2: PWR
Link
terminator
(LT-1)
Control Station Devices
4
1
3
2
2
3
1 4
Data Link
(1) shielded, twisted pair #18 AWG (1.0 mm
3: MUX
4: MUX
D: Drain wire in shield - Connect together to make one continuous link
shield. Keep away from ground and control electronics.
Installation of GRAFIK 5000/6000/7000 System
Last Control Station Device on Link
4 4
3 4
3 3
2 2
1 1
Link
terminator
(LT-1)
2
)
17