Chest Belt Instructions - Skandika Fitness ELITE PRO Instructions De Montage Et Mode D'emploi

CHEST BELT INSTRUCTIONS

The transmitter chest belt will detect your heart rate and will transfer the information to the computer
(or compatible device e.g. pulse watch) by wireless signal.
The receiving appliance can then display your heart rate frequency.
The measurement procedure with this chest belt is very accurate and resistant to disturbances. The
wireless signal is transmitted via low frequency technique.
The chest belt is sufficiently protected against your sweat during exercise.
Features
• transmission frequency 5.3 kHz
• Compatible with Pulse Watches
• transmission range 150-180 cm
1 pc. CR2032 battery – if used 1 hour per day the energy will be sufficient for 10 months of use
•
How to wear the chest belt
You may adjust the belt to a comfortable length. However, the electrodes must have contact with your
skin in order to measure your heart rate correctly. It may last up to one minute before a correct display
can be seen.
Moisten the electrodes slightly before wearing the belt. This increases the contact sensibility and ena-
bles a better wireless signal transmitting.
Tip: The battery compartment lid should face the outside.
Battery replacement
If the signal transmission is insufficient, you may need to replace the battery. Use a screwdriver to
open the battery compartment cover. Replace the old battery by a fitting new one (CR2032). Make
sure, the battery is inserted the right way around ("+" side facing up). Put the battery compartment
cover back and fix it with the screws.
Remarks
1. If your skin is too dry, the chest belt may not be able to measure your pulse rate correctly. Moisten
your skin and the electrodes slightly and try again.
2. If your chest hair is too dense, the chest belt may not be able to measure your pulse rate correctly.
Please only use the belt if your chest hair is not too dense.
30