Assembly Instructions - Skandika Fitness REGATTA MULTIGYM POSEIDON Mode D'emploi / Instructions De Montage

ASSEMBLY INSTRUCTIONS

Step 1
(see pic. 1)
Connect the front stabilizer (3) to the main frame (21) by use the bolt M8*47 (2), Curved cushion φ8
(47) and lock nut M8 (13).
Connect the computer (44) wire to the upper computer wire (45), then fix the computer on the compu-
ter bracket of main frame (21)
Step 2
(see pic. 2)
Connect the seat (71) to the seat bracket (67) by use the Screw M6*15 (65) and flat washer (66) then
ock Adjustment knob (58).
PS: Adjust the Seat to the position using Adjustment knob (58).
Step 3
(see pic. 3)
Connect the rear stabilizer (61) to the roller tube (53) by use the bolt (60) and screw (M6*10) (64).
Step 4
(see pic. 4)
1. Put the roller tube (53) into main frame (21) and then assemble by use bolt M8*95 (20), Washer
(14) and lock nut M8 (75).
2. 2. Connect the upper computer wire (45) to the lower computer wire (52),
3. 3. Insert the pin (18).
Step 5
(see pic. 5)
Buckle the handlebar hook (32) with weave belt hook (17) then put on handlebar bracket (37).
Attention: There are 3 levels of tension. Tension level varies on the number of belts, 1 belt for
least resistance, 3 belts for highest resistance.
Please change the weave belts (17), a consuming parts when it is damaged or the diameter shrinks.
The defect photo and changing procedure are as below:
Step 6
(see pic. 6)
Assembly Pedal (15), Bushing (19) and (Axle for Pedal) (16) to the Main frame (21) by use lock nut
M8 (13) and Washer (14).
Folding for storage
Pull the pin (18) out of the main frame (21), then turn roller tube (53) anticlockwise, insert pin (18) to
the hold.
12
(see pic. 7)