Assembly Instructions - Skandika Fitness MORPHEUS Instructions De Montage Et Mode D'emploi

ASSEMBLY INSTRUCTIONS

Step 1
Attach the front stabilizer (2) to the front part of the main frame (1) with 4 curved washers (16) and 4
allen bolts (15).
Attach the rear stabilizer (3) to the rear part of the main frame (1) with 4 curved washers (16) and 4
allen bolts (15).
Step 2
Connect the upper sensor wire (33) to the lower sensor wire (34).
Insert the front support (4) into main frame (1) and secure with two flat washers (18), two curved
washers (16) and four allen bolts (15).
Step 3
Attach the handlebars (5) to the front support (4) and fasten with one clamp (25), one allen bolt (22),
one clamp cover (37) and one T-type knob (21).
Connect the upper sensor wire (33) to the sensor wire on the back of the computer (6). Insert the hand-
pulse wire (20) through grommet (32) on front support (4) and pull it out of front support (4). Connect
the hand pulse wire (20) to the jack on the back of computer (6).
Attach computer (6) to front support (4) using four screws (27) [pre-assembled on computer].
Step 4
Attach sliding seat cover (12) to seat support (7) using one self-tapping screw (39).
Loosen two nuts on back of seat (8) and re-attach it to seat support (7) and fix the seat (8).
Insert the seat support (7) into decorative cover (38). Attach the seat support (7) to main frame (1) and
fasten with one quick release knob (11).
Step 5
Attach the right pedal (10) onto the right crank and
tighten it by turning it clockwise.
Then attach the left pedal (9) onto the left crank and
tighten it by turning it anticlockwise.
The pedals are marked with "R" (right) and "L" (left).
Adapter
Step 6
Connect the adapter jack to rear part of main frame
Adapter jack
(1) as shown:
23