Mowing; Working Instructions; Cleaning And Maintenance - Grizzly BRM 51 BSA Mode D'emploi

UK
2. Pull the safety catch (3) towards
the handle bar and hold it.
3. Pull the starter cord (22).
4. When the engine starts, allow
the starter handle to slowly slide
back into the starter cable guide
(21).
Stopping the Engine:
• Release the safety catch (3), the en-
gine stops and the blade is slowed

Mowing

1. Start the engine (see
2. Set petrol lever (23) to position
.
3. Wheel drive:
On: Pull the drive catch 2)
towards the handle bar. The
mower moves forwards.
Off: Release the drive catch (2)
The equipment stops.
Set petrol lever (23) to position
for short breaks and to re-
duce noise
The change in motor revolutions
via both positions
does not influence the speed of
the power wheels. They cannot be
regulated.

Working Instructions

• As far as possible, mow the lawn when
it is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
82
•
•
•
•
). •

Cleaning and Maintenance

+
lines should always overlap by a few
centimetres.
Do not move backwards.
On slopes, always work across the
slope.
If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
For cleaning and maintenance
work, also observe the Briggs &
Stratton instruction manual sup-
plied.