Mowing; Working Instructions; General Working Instructions; Setting The Cutting Height - Grizzly BRM 46-160 H Traduction De La Notice D'utilisation Originale

Motor stop:
• Release the safety loop (2). The
motor switches off and the knife is
braked.
When you have fi nished mowing,
close the petrol tap (32) by turning
counterclockwise.
Knife stopping device:
Regularly examine the knife stopping
device: Release the safety loop (2). The
motor switches off and the knife is braked.
The knife must stop within 7 seconds.

Mowing

1. Start the engine (see
2. Hold the grip handle (1) and the
safety loop (2) with both hands
while mowing.

Working Instructions

General Working Instructions

• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during longer
breaks and for transportation and wait
until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.

Setting the Cutting Height

The equipment has 10 positions for setting
the cutting height (25-75 mm):
1. Pull the lever (18) outwards and
2. Push the lever (18) back in.
The correct cutting height is around
+ ). 30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the fi rst cut of the season.
Cleaning and
Maintenance
Have any repair and maintenance
work not described in these in-
structions carried out by a spe-
cialist workshop. Use only origi-
nal Grizzly replacement parts.
Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool be-
fore any maintenance and clean-
ing work. Elements of the engine
are hot. Risk of burning!
Wear gloves when handling the
blade.
push it to the desired position (33).
GB
89