Filling With Petrol; Setting The Cutting Height; Operation; Starting And Stopping The Engine - Grizzly BRM 51 BSA Mode D'emploi

Filling with Petrol

Warning! Petrol is flammable
and hazardous to health:
- Keep petrol in containers intended for
this purpose;
- Only refuel outdoors and never with
the engine running or when the ma-
chine is hot;
- Open the filler cap carefully to allow
excess pressure to escape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhalation of
the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks, open
flames and other ignition sources;
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates
1. Unscrew the filler cap (
pour in the petrol to the lower edge of
the filler.
Do not fill the tank entirely, to allow
the petrol room to expand.
2. Wipe away petrol residues around the
filler cap and close the filler cap.

Setting the Cutting Height

The equipment has 10 positions for set-
ting the cutting heigh (25-75 mm):
1. Pull the lever (18) outwards and
push it to the desired position .
2. Push the lever back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.

Operation

Starting and Stopping the
Engine
8) and
Select a greater cutting height for
the first cut of the season.
Observe the noise protection and
local regulations.
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Cold start:
1. Set petrol lever (23) to position
.
2. Press the petrol pump (13)
(primer) 3x (small picture).
3. Pull the safety catch (3) towards
the handle bar and hold it.
4. Pull the starter cord (22).
5. When the engine starts, allow
the starter handle to slowly slide
back into the starter cable guide
(21).
Warm start:
1. Set petrol lever (23) to position
.
UK
81