Install/Empty Grass Catchment Basket; Installing The Starter Cord; Filling With Engine Oil And Checking The Oil Level - Grizzly BRM 51 BSA Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
UK
1. With a wrench (size 13) remove
bar mounting and nuts (24) on
equipment
2. Attach lower handlebar (4) with
screws and nuts (24) of handle-
bar.
3. Unfold upper handlebar (1) (small
picture) and push locking lever
(20) toward bar.
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Push basket rods (25) into bas-
ket net (26).
2. Pull plastic loops (27) over bas-
ket rods.
Fixing the Grass Collection
Box onto the Equipment:
3. Lift up shock protection (6).
4. Hook the grass collection box
(19) into the mounting provided
for this (28) on the rear of the
equipment.
5. Release the impact protection
(6). It holds the grass collection
box in position.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (6) and
remove the grass collection box
(19)
80
7. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.

Installing the Starter Cord

1. Pull the safety catch (3) towards
the handle bar (1) and hold it.
2. Slowly pull the starter cord on
the starter handle (22) towards
the bar and hook the starter
cord into the starter cord guide
(21).
3. Release the safety catch (3).
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil filler cap and dipstick
(
7) and pour oil into the tank. The
oil tank holds 0.6 l oil. Use brand oil
(e.g. SAE 30).
2. To check the oil level, wipe the dip-
stick on a clean cloth and replace it in
the tank until it stops.
3. After pulling it out, read off the
oil level on the dipstick. The oil
level should be in the marked
area between the minimum and
maximum marks.
4. Wipe off any spilt oil and close
the oil filler cap (
Check the oil level every time be-
fore mowing and add oil when the
lower marking point is reached.
7).

Publicité

Table des Matières
loading

Table des Matières