Mowing; Working Instructions; General Working Instructions; Setting The Cutting Height - Grizzly BRM 4210-20 Traduction De La Notice D'utilisation Originale

GB
3. Pull the starter handle (7).
4. If the motor starts slowly, re-
lease the starter handle into the
starter rope-guide (3).
For a warm start it is not neces-
sary to press the primer (32).
If the primer is pressed too often, too
much petrol will enter the carburettor
and the motor is difficult to start.
Motor stop:
• Release the safety loop (2). The
motor switches off and the knife is
braked.
Knife stopping device:
Regularly examine the knife stopping
device: Release the safety loop (2). The
motor switches off and the knife is braked.
The knife must stop within 7 seconds.

Mowing

1. Start the engine (see
2. Hold the grip handle (1) and the
safety loop (2) with both hands
while mowing.
92

Working Instructions

General Working Instructions

• As far as possible, mow the lawn when it
is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed in
lines that are as straight as possible. For
uninterrupted mowing, the lines should
always overlap by a few centimetres.
• Do not move backwards.
• On slopes, always work across the slope.
• If the blade comes into contact with a
foreign body, switch off the engine imme-
diately. Wait until the blade is stationary
and check the equipment for damage.
Restart work only if the equipment is un-
damaged.
• Switch off the equipment during longer
breaks and for transportation and wait
until the blade is stationary.
• Clean the equipment after each use, as
described in the "cleaning and mainte-
). nance" chapter.

Setting the Cutting Height

The equipment has 5 positions for setting
the cutting height (25-37-50-62-75 mm):
1. Pull the lever (17) outwards and
2. Push the lever (17) back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
push it to the desired position (33).
Select a greater cutting height for
the first cut of the season.