Mowing; Self Propelling; Working Instructions; Cleaning And Maintenance - Grizzly BRM 51-159 A-OHV Quattro Traduction De La Notice D'utilisation Originale

UK
3. When the engine starts, allow the
starter handle to slowly slide back
into the starter cable guide (21).
Stopping the engine:
4. Release the safety loop (3). The
motor switches off and the knife
is braked.
Regularly examine the knife
stopping device:
Release the safety loop (3). The
motor switches off and the knife is
braked. The knife must stop within
7 seconds.

Mowing

1. Start the engine (see
2. Wheel drive:
On: Pull the drive catch (2)
towards the handle bar. The
mower moves forwards.
Off: Release the drive catch (2)
The equipment stops.

Self propelling

Self propelling is switched on by pressing
the safety loop (3) on the handle (1) and
simultaneously pulling the drive bracket
(2) in the direction of the handle (1) until
a click is heard. Release the drive bracket
(2).
The forward movement of the self pro-
pelling ends when the safety loop (3) is
released.
In order to stop self propelling without
switching off the engine, release the safe-
ty loop (3) slightly until the self propelling
decouples. Pull the safety loop on the
handle (1) again and proceed with mow-
ing without self propelling.
86

Working Instructions

• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
)). stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
Cleaning and Mainte-
nance
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and clean-
ing work strictly with the engine
switched off and spark plug con-
nectors removed. Risk of injury!