Installing The Handle Bar; Install/Empty Grass Catchment Basket - Grizzly BRM 51-2 BSA Traduction De La Notice D'utilisation Originale

GB
Before starting the equipment, you must
- Remove the Protective Caps
- Install the handle bar
- Install the grass collection box
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- adjust cutting height if required

Installing the Handle Bar

Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. With a wrench (size 13) remove
bar mounting and nuts (23) on
equipment
2. Attach lower handlebar (4) with
screws and nuts (23) of handle-
bar.
3. Unfold upper handlebar (1)
(small picture) and push locking
lever (19) toward bar.
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Push basket rods (24) into bas-
ket net (25).
2. Pull plastic loops (26) over bas-
ket rods.
86
Fixing the Grass Collection
Box onto the Equipment:
3. Lift up shock protection (6).
4. Hook the grass collection box
(18) into the mounting provided
for this (27) on the rear of the
equipment.
5. Release the impact protection
(6). It holds the grass collection
box in position.
Grass bag filling indicator
A textile display is attached to
the top of the grass bag (18).
At an empty grass bag inflates
the fill indicator in the operating.
The fill indicator to coincide in
full catcher. In this case, imme-
diately empty the grass bag.
In heavily polluted grass bag fa-
bric the fill indicator can not inflate
himself. The function of the check
indicator is not guaranteed. Imme-
diately clean the grass bag fabric.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (6) and
remove the grass collection box
(18)
7. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.