Mount The Front Wheel; Installing The Handle Bar; Install/Empty Grass Catchment Basket - Grizzly BRM 46-141 AT-OHV Traduction De La Notice D'utilisation Originale

Before starting the equipment, you must
- Remove the Protective Caps
-

mount the front wheel

- Install the handle bar
- if necessary, mount the grass collec-
tion box, mulch kit, lateral ejection
canal
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- Adjust cutting height if required
Mount the front wheel
1. From the back, insert the
screws through the openings
(the longer screws must be fit-
ted into the lower hole) and fas-
ten the rods of the front wheel
with the nuts.
2. Now fasten the cladding on
to the lower, still protruding
screws.

Installing the Handle Bar

Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. There is a drill hole located on
the lower end of the handle bar
which is tightened using the cor-
responding bolts in the holder
on the device. This creates the
lower pivot point used to adjust
the tilt angle.
2. Fasten the lower handle bar (4)
using the bar fastening screws
and nuts. (Use the mounting
wrench
You can determine the desired
tilt by selecting one of the pos-
sible screw positions.
33.)
D
3. Unfold upper handlebar (1)
(small picture) and push locking
lever (20) toward bar.
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
Pull plastic loops (29) over bas-
ket rods. Insert the handle into
the collection box and fasten it
with the associated screw.
Fixing the Grass Collection
Box onto the Equipment:
Prior to using the collection box,
the mulch kit and lateral ejection
canal must be removed. (see
).
3. Lift up shock protection (6).
4. Hook the grass collection box
(19) into the mounting provided
for this (30) on the rear of the
equipment. .
5. Release the impact protection
(6). It holds the grass collection
box in position.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (6) and
remove the grass collection box
(19)
GB
,
83