Operating Instructions; Start-Up; Changing The Lpg Cylinder; Hose Change - Truma MonoControl CS Mode D'emploi

Operating instructions

Start-up

Open the gas remote switch if present.
1.
Figure 1
1. Open the cylinder valve.
2. Firmly press the hose rupture protection (green button) on
the high-pressure hose for about 5 seconds.
3. If necessary (e.g. after a new installation or inadvertently
striking the gas cylinder against the gas pressure regu-
lation system), press the green reset button (crash sensor
triggering element reset) on the MonoControl CS for about
5 seconds.
14
2.
3.

Changing the LPG cylinder

Use the included screw aid to attach and remove the
high-pressure hoses. It will help you generate the necessary
tightening torque and will prevent damage to the screw fit-
tings, which may otherwise result from using an improper tool.
Residual gas: No smoking, no naked flames!
– Close the valve of the empty gas cylinder.
– Remove the high-pressure hose from the gas cylinder and
remove the slip-on adapter, if present.
– Attach the high-pressure hose to the full gas cylinder and fit
the slip-on adapter, if present. Inspect the gas filter for the
presence of residues.
– Open the full gas cylinder's valve.
– Firmly press the hose rupture protection (green button) and,
if necessary, the green reset button for about 5 seconds in
each case.
After any intervention, check the hose connection to the
cylinder valve for leaks (see "Checking for leaks in the
high-pressure section").

Hose change

Please use the included screw aid to attach and remove the
high-pressure hoses. It will help you generate the necessary
tightening torque and will prevent damage to the screw fit-
tings, which may otherwise result from using an improper tool.
Residual gas: No smoking, no naked flames!