Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Switching off:
Switch in middle position (b).
Only electrical functions
are switched on and off
using the control panel. The
gas supply itself is mechani-
cally opened and closed at
the gas cylinders. Truma pro-
vides a remote gas switch for
shutting off the gas supply
from a central location.
Please seek advice from a
specialist dealer.
Changing Cylinders
The gas pressure regulator kit
provides you with a facility
for replacing an empty gas
cylinder without interrupting
consumer operation (equip-
ment is supplied with gas
from spare cylinder).
If an indicator palm goes off
(A or B), the relevant gas
cylinder is empty. Close valve
at empty gas cylinder and un-
screw regulator from cylinder.
When changing cylin-
ders, do not smoke
and keep away from naked
flames!
After changing an empty
gas cylinder, switch the gas
supply to the other cylinder
by simply turning the rotary
knob (1) by 180°. The previ-
ous spare cylinder now be-
comes the used cylinder. The
new, full gas cylinder is now
available as the spare cylinder.
Leak test
1. Turn all equipment off.
2. Open gas cylinders and
rapid shut-off valves in gas
pipes.
3. Read off pressure at pres-
sure gauge (2) and close gas
cylinders again.
4. If the pressure gauge (2) is
still indicating the same
pressure after 10 minutes,
the gas system is leak-free.
If the pressure drops the
gas system is leaking and
must be repaired by an ex-
pert immediately. Do not
open bottle valves again!
This leak test only
provides a rough indi-
cation and is not a substitute
for the proper regular gas
test!
Technical Data
Voltage: 12 V
Power consumption
Summer mode: 20 mA
Winter mode: 620 mA
Operating pressure
Central regulator:
30 or 50 mbar
Changeover regulator: 100 or
220 mbar (depending on
changeover valve position)
Flow rate: 1.5 kg/h
Regulator outlet
connection:
Outer thread H.4
(corresponds to 1/4"
anticlockwise)
Conformity Declaration:
The Truma Duomatic L Plus
gas pressure regulator set
complies with the pres-
surised equipment directive
97/23/EC, with use of
EN 12864/D and
prEN 13786/B. The gas pres-
sure regulator set is equipped
with a safety valve so that
pressures in excess of
100 mbar cannot reach the
equipment if a fault occurs.
Product Identification
Number: CE-0085BN0539
EEC Type Approval:
e1 022603
Installation
Instructions
The operating pressure
of the Duomatic L Plus
(30 or 50 mbar – see printing
on central regulator „A")
must correspond with the op-
erating pressure of the equip-
ment installed in the vehicle!
Equipment must always
be installed by an expert!
The Duomatic L Plus is only
approved for caravans and
campers where the gas cylin-
ders are placed in the open or
in cupboards that are sealed
from the vehicle interior!
Installation in commercially
used vehicles, closed spaces
(households), mobile homes
(statics) or boats is not per-
mitted.
When using vehicle-specific
or manufacturer-specific con-
trol equipment the electrical
connection must be made in
accordance with the Truma
interface description.
7
Publicité
Table des Matières
